Tigé 24Vé (2009-)

Brief Summary

The flagship of Tigé’s Vé series, this 24Vé includes generous wraparound cockpit seating and a walk-across deck aft to the stern platform. The transom activity center offers a seat over the stern platform, plus storage for gear that’s easily misplaced. Tigé’s patented TAPS wake control system lets this 24-footer convert from skiboat to wakeboarder in just a few seconds.

Key Features

• All-composite floor with ¾’’ fiberglass-reinforced Urethane Core
• Armorflex anti-blistering gelcoat
• Hand-laid multi-directional fiberglass hull
• Vinylester barrier coat
• Waterbonnet curved glass windshield
• Flip-up bolster seat
• Stainless steel hardware throughout
• Oversized removable teak swimstep
• PCM power train

Test Results

Specifications

Length Overall	24' 0''
Beam	8'6''
Dry Weight	4,320 lbs.
Draft	26''
Deadrise/Transom	N/A
Max Headroom	open
Bridge Clearance	N/A
Fuel Capacity	48 gal.
Water Capacity	none

Acceleration Times & Conditions

Time to Plane	3.8 sec.
0 to 30	6.1 sec.
Ratio	1.48 : 1
Props	13 1/2 x 16 4 Blade Bronze ACME
Load	3 persons, Full Fuel, water N/A, gear 400 lbs.
Climate	Temp 88, Humidity 50, Winds 20-25 mph, Seas moderate chop

Engine Options

Tested Engine	1 x 343-hp PCM EX 343 5.7L
Std. Power	1 x 343-hp PCM EX343 5.7L
Opt. Power	1 x 409-hp PCM 6L ZR409

Warranty

Deck Warranty Extended	LifePlus Limited Replacement Warranty
Hull Warranty Extended	LifePlus Limited Replacement Warranty

Captain's Report

Tigé 24Vé
By Capt. Vince Daniello
Tigé (pronounced like tiger without the “r”) has revamped their boats’ styling and added a few convenience features – most notably a walk-over deck next to the sunpad and enhanced storage at the transom – to create their Vé series. While the traditional V and Vé series are built on similar hulls, there are some slight differences such as the distinctive hour-glass shaped transom on the 24Vé, which not only adds to the boat’s appearance, but creates a small deck at the stern of the boat. This “activity center,” as Tigé calls it, offers a seat where it’s needed most on a watersports boat – at the swim platform. Beneath this deck, three long, shallow storage compartments keep hats, sunglasses, gloves, binding soap, even tow ropes back at the stern where they’re easy to find. All three compartments are insulated and drain overboard, so any or all can store cold drinks as well.
Deck Layout
Tigé’s walk-over deck provides a nonskid pathway between the swim platform and the cockpit, and also a safe, convenient way to board the boat from the dock. While this does take a bit of space away from the sunpad, it does not reduce seating inside the boat, with a full wrap-around cockpit. To save foot traffic on the seats the cushion in front of the walk-over is carpeted on its bottom, so flipping this seat cushion over provides a place to step without muddying the upholstery. This simple feature will help keep the interior looking new, but because this carpeted step is supported by the squishy foam of the seat cushion I found it just a bit unstable – probably better footing than stepping directly onto a foam seat, but not as rock-solid as it appears to the uninitiated.
Cockpit Features
In addition to its ample seating, the cockpit offers plenty of storage too. Skis can slide under the seat on the port side, where they’re also easy to grab from the swim platform, through a hatch beneath the sunpad. There are two big coolers aboard: one drink cooler under the seat just behind the windshield on the port side, and a large removable Igloo secured beneath the transom walk-over hatch. Accessing the Igloo requires a bit of a reach down into the storage compartment and could be easier to open, but with drinks in the cockpit and at the transom, this shouldn’t be a problem.
Hull Design
Many wakeboard boats sacrifice storage space to ballast tanks and pumps, but Tigé’s TAPS system solves this problem. The more I played with TAPS, Tigé Adjustable Performance System, the more I appreciated Tigé’s “outside the box” thinking.
When first testing a TAPS boat my initial reaction was that the boat required too much adjustment to the trim to get its best performance, which led me to believe that the hull was not designed as well as it could have been. But now that I understand TAPS, I see that my instinctive reaction based on years of evaluating boat’s performance in traditional terms is precisely what has held back wakeboard boat design until now.
Tigé designed their hull as a non-planing hull. At wakeboarding speeds the bow rides high and the boat settles naturally, creating massive water displacement and a big wake without the need for ballast weight. The TAPS plate, essentially a large trim tab in the center of the boat, allows the driver to control how much the boat planes, and therefore how big a wake it makes. In our tests of the 24Vé, we were able to go from a flat slalom wake to a full wakeboard wake in just a few seconds. But it wasn’t the quick conversion that caught my attention. What is interesting about TAPS compared to other wake enhancement systems is that it allows the wake size to be tweaked while the wakeboarder is riding behind the boat, adjusting to the rider’s skill level, fatigue, or sea conditions.
On the Water
Our test boat’s 343-hp PCM EX 343 5.7L inboard gave us a top speed of 43 mph with a 13 ½ by 16 inch 4-blade prop and a 1.48 to 1 reduction ratio ZF transmission. At a comfortable speed of 22.4 mph we traveled 3.25 mpg for a 140 mile range, showing the advantages of the Convex V hull and TAPS.
Designing boats is a compromise, and manufacturers are always trying to build a better mousetrap. We’ve all been in the same boat, where the latest and greatest design turns out to be more sizzle, less steak. But before settling for the cliché that wakeboard boats need ballast, check out the TAPS system. It just may be the greatest thing since sliced bread.